With colder weather coming soon, compressed air systems that are subject to lower temperatures may deal with slow starting, possible control line freeze problems, and condensate lines freezing. To help prevent some of these problems, heat lamps can be installed close to the lines to prevent freezing. Also, applying heat tape with a thermostat to control lines and condensate lines is a great way to protect your equipment located outside. However, keep in mind that anything installed on the lines themselves might have to be removed when the equipment is being serviced.
Here is a basic cold weather diagnostic outline:
- Check insulated areas and make sure the heat is staying inside and the cold is staying outside.
- Also check any weather stripping and replace areas that are worn out and not working properly.
- Check condensate drains throughout your system for proper operation. Excess water in your lines and freezing temperatures are not a good mix.
- Check the intake for your air compressor. If it’s exposed to the outside elements, your inlet air filter can be damaged from ice and snow.
- Compressed air receivers should be protected as well. If condensate is allowed to collect at the bottom of the tank it can freeze. Insulate any outside pipes feeding the tank as well as the condensate drain for the tank.
- Kind of a no brainer here, but make sure your compressed air dryer and compressed air filters have been serviced and are operating correctly. Their job is to remove condensate from your compressed air system. The less condensate in the system the less there is to freeze and cause problems.
Contact us today if you need any help with addressing your cold weather vulnerabilities. Taking these proactive steps now, can help prevent some major problems once it turns cold outside.